Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation



Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburettors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Ignition system
+ 8. Transmission
+ 9. Suspension brackets, wheels
+ 10. Brake system
+ 11. A steering
+ 12. A body, salon
+ 13. A central air
- 14. An electric equipment
   + 14.1.2. A thermoswitch, an electronic thermoswitch
   - 14.2. Electroconducting
      14.2.2. Updating rubber изоляционной plugs of the contact plug
      14.2.3. Holders of additional safety locks
      14.2.4. The locations and identification of safety locks
      14.2.5. Identification of contacts on a payment of safety locks and relay blocks
      14.2.6. An additional payment of blocks of the relay
      14.2.7. The locations of tips of a plait of wires in contact nests
      14.2.8. Points of grounding and welded connections of wires
      14.2.9. The locations of blocks of management
      14.2.10. An arrangement of devices in engine branch
   + 14.3. Electroschemes




14.2.3. Holders of additional safety locks
THE GENERAL DATA

And – a casing of a payment of safety locks and relay blocks

In – a payment of safety locks and relay blocks

With – additional safety locks and their holders

In cars, since models 1990, holders of additional safety locks act in film and established separately. Holders are attached to an inside of a casing of a payment of safety locks and relay blocks.

Identification of holders of additional safety locks on colour

S 23 – black
S 24 – blue
S 25 – red
S 26 – yellow
S 27 – brown
S 28 – white
S 29 – green
S 30 – grey

The prevention

Use of eight additional safety locks is possible. For correct installation of safety locks use the suitable scheme of electroconducting.


The red plastic cap with a designation "Motor" is established on safety locks of system of the electronic control of the engine to avoid casual removal of safety locks.

Removal

PERFORMANCE ORDER
1) uncover payments of safety locks and relay blocks
2) disconnect (having hooked latches) a payment of safety locks from a casing (without disconnecting electric connections) and will put it aside
3) using a small screw-driver, release a blocking ear of the additional holder of a safety lock

4) press on the holder in a direction specified by an arrow and get it from a casing of a payment of safety locks

Installation

PERFORMANCE ORDER
1) insert the holder of an additional safety lock on the place, the blocking ear will not be latched yet
2) insert a payment of safety locks into a casing
3) establish a casing cover on the place