Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation



Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburettors
3. Greasing system
+ 4. Cooling system
- 5. Fuel system
   - 5.2. Systems of injection of fuel
      5.2.1.2. Specifications (4-cylinder models)
      5.2.1.3. Components of system of injection for 5-cylinder models
      5.2.1.4. Specifications (5-cylinder models)
      5.2.1.5. A starting position of a plate of the gauge of an air stream
      5.2.1.6. A free wheeling of a plate of the gauge of an air stream
      5.2.1.7. The lever of a plate of the gauge of an air stream
      5.2.1.8. Operating плунжер
      5.2.1.9. The throttle valve
      5.2.1.10. A rope of management throttle заслонкой
   5.2.2. Fuel injectors (20-klapannye models)
   + 5.2.3. An electronic control system of engine MPI
+ 6. An exhaust system
+ 7. Ignition system
+ 8. Transmission
+ 9. Suspension brackets, wheels
+ 10. Brake system
+ 11. A steering
+ 12. A body, salon
+ 13. A central air
+ 14. An electric equipment




5.2.1.10. A rope of management throttle заслонкой
THE GENERAL DATA

Rope of management throttle заслонокой, an arrangement of components (4 and 5-cylinder models
)
 
1. The throttle case
2. A basic arm
3. The rotary plug
For removal of the lever of a pedal break off fixing ledges (do not use repeatedly damaged rotary plugs)
4. The pedal lever
Acts in film only together with rotary plugs
5. A gas pedal
6. The rotary plug
7. A rope of management throttle заслонкой
8. A clamp

Adjustment

PERFORMANCE ORDER
1) at completely squeezed out pedal of gas the lever of the throttle valve should reach only just positions completely open throttle заслонки (a free wheeling on the throttle lever – a maximum of 1 mm)
2) if it not so
Adjust a rope, inserting a clamp (it is specified by an arrow) at a basic arm

Removal

PERFORMANCE ORDER
1) disconnect a rope from a basic arm of a pedal and the lever of the throttle valve
2) break off fixing ledges from within salon (do not use repeatedly damaged ropes) and extend a rope through an engine compartment
3) replace linings and ring consolidations
4) fix connections of hoses by screw or spring clips
5) for correct work of components of electric system pressure a minimum of 11.5 volt is necessary

The prevention

Inflammably! Do not smoke and do not bring to area of repair anything from this that can ignite fuel.