Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation

9.3.2. Disorder / a convergence of wheels

THE GENERAL DATA

Adjustment of installation of wheels

It is recommended to inspect adjustment of wheels after at least 1000–1200 km of run when suspension bracket springs had time to enter into a normal operating mode.

For check it is necessary:

      – Exact adjustment of the measuring equipment;
      – That the weight of the car at check carrying out equaled only to its own weight with the filled tank and the established equipment;
      – That pressure in tyres equaled to the standard;
      – That the car has been located on an equal surface, also before carrying out of check the car is necessary for rocking some times to establish a suspension bracket;
      – That there was no excessive free wheeling in the steering mechanism;
      – Check up a suspension bracket on presence of an excessive free wheeling and damages.

Cars with a forward drive

Forward wheels	Rating values
Convergence of forward wheels (on wheels there is no pressure)	+10 ' 10'
Disorder of forward wheels
Wheels stand directly	-45 ' 30'
The maximum admissible distinction between the left and right wheel	30'
Difference in convergence coal between left and right wheels	-55 ' 30'
Corner of a longitudinal inclination шкворня
It is not regulated	+115 ' 30'
The maximum admissible distinction between the left and right wheel	30'

Back wheels	Rating values
Disorder of back wheels
It is not regulated	-1 ' 20'
The maximum admissible distinction between the left and right wheel	30'
Convergence of back wheels
It is not regulated