Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation



Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburettors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Ignition system
+ 8. Transmission
+ 9. Suspension brackets, wheels
- 10. Brake system
   10.1.2. Brake Pads forward brakes
   10.1.3. Brake Pads back brakes
   10.1.4. The general adjustment of back brakes (Girling)
   10.1.5. Replacement brake колодок (all-wheel drive models)
   10.1.6. The general adjustment of back brakes (Girling) (all-wheel drive models)
   10.1.7. Plugs of pedals of a brake and coupling
   10.1.8. Adjustment of a manual brake
   10.1.9. Removal of the lever of a manual brake
   + 10.2. Hydraulic components
   + 10.3. Antiblocking system of brakes
+ 11. A steering
+ 12. A body, salon
+ 13. A central air
+ 14. An electric equipment




10.1.7. Plugs of pedals of a brake and coupling
THE GENERAL DATA

Brake pedal / the Hydraulic booster of brakes

1. At плотнительное a ring
Establish on an arm of pedals before installation of the hydraulic booster of brakes
2. An arm of pedals
Remove at removal of pedals of a brake or coupling
3. A returnable spring of a pedal of coupling
Do not grease a spring
4. A clip
5. The main brake cylinder
Repair or replace, if it proceeds
6. 20 Н.м.
7. A counternut
8. A pin
9. A plug
10. A clip
Always replace
11. 25 Н.м.
Always replace
12. Колодка pedals
13. A coupling pedal

14. The stoplight switch
Adjustment: press a brake pedal
Insert the stoplight switch against the stop
Hand pull out a brake pedal back against the stop
15. A clip
16. A pin
17. A brake pedal
18. An accelerator pedal
Fastens to an arm by means of a clip
19. A clip
20. A plug
21. A counternut
22. A returnable spring
Establish the bent end on a brake pedal
23. 25 Н.м.
Always replace
24. 10 Н.м.
25. The hydraulic booster of brakes
To replace entirely
Before installation, adjust a plug

Adjustment of a plug of a pedal of a brake

PERFORMANCE ORDER
And = 269.0 + 0.5 mm

The prevention

At carrying out of measurements draught should be at right angle to an amplifier surface.



Plug of a pedal of coupling, adjustment

PERFORMANCE ORDER

And = 116.0 + 0.2 mm

The prevention

If the coupling pedal does not come back in initial position though the plug is adjusted correctly, it can be caused that in hydraulic systems air or the pedal plug too hard has got.