Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburettors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Ignition system
+ 8. Transmission
+ 9. Suspension brackets, wheels
- 10. Brake system
10.1.2. Brake Pads forward brakes
10.1.3. Brake Pads back brakes
10.1.4. The general adjustment of back brakes (Girling)
10.1.5. Replacement brake колодок (all-wheel drive models)
10.1.6. The general adjustment of back brakes (Girling) (all-wheel drive models)
10.1.7. Plugs of pedals of a brake and coupling
10.1.8. Adjustment of a manual brake
10.1.9. Removal of the lever of a manual brake
+ 10.2. Hydraulic components
+ 10.3. Antiblocking system of brakes
+ 11. A steering
+ 12. A body, salon
+ 13. A central air
+ 14. An electric equipment
|
Manual brake
|
1. A rotary pin
2. A cover
3. The lever of a parking brake
4. The handle
Put on the lever so that the latch on the lever has got to a loop on the handle
5. The deenergizing button
It is wound on a pusher
6. A kompressionnaja spring
7. A latch
8. The doggie
9. The switch
For an alarm bulb of a manual brake
10. A sheet spring
|
11. A lock ring
Check up correctness of installation
12. A cover
13. The equalizer
14. An adjusting nut
15. The bearing
16. A rotary pin
Grind off a head for rivet replacement at installation of a new pin
17. Draught
18. A rotary pin
Grind off a head for rivet replacement at installation of a new pin |
Adjustment of a manual brake As back brakes are self-regulated, it is necessary for you to spend their adjustment only after replacement: ropes of a manual brake, supports of brakes, brake disks, brake колодок.
Always in the beginning spend the general adjustment of back brakes.
| PERFORMANCE ORDER |
| |
1) tighten an adjusting nut of a rope of a parking brake so that both levers (one of them is specified by an arrow) have risen from an emphasis (two mechanics are for this purpose necessary) |
|
2) twirl an adjusting nut (it is specified by an arrow) back on two turns |
| |
3) by means of a screw-driver take away the support lever against the stop by turns on both back wheels |
| 4) a rope of a manual brake will pull too strongly if the lever of one of supports departs from an emphasis |
| 5) ослабьте an adjusting nut of a rope of a manual brake (it is specified by an arrow) so that both levers have fallen on an emphasis |
| 6) put the car on a manual brake, and then remove |
| 7) check up, that both wheels rotated freely |
|
|
|