Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation



Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburettors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Ignition system
+ 8. Transmission
- 9. Suspension brackets, wheels
   9.1.1. Elimination of a resonance / of vibration of a cross-beam (4-cylinder models)
   9.1.2. Change of a design of a forward suspension bracket
   9.1.3. Полуось
   9.1.4. A suspension bracket rack
   9.1.5. SHRUS
   9.1.6. A suspension bracket rack (all-wheel drive models)
   9.1.7. SHRUS (all-wheel drive models)
   - 9.2. A back suspension bracket
      9.2.1. An oil cap
      9.2.2. Bearings of a nave of a wheel
      9.2.3. Removal and installation of the back bridge
      9.2.4. A suspension bracket rack
      9.2.5. Change of a design of a back suspension bracket
   + 9.3. Wheels and tyres
+ 10. Brake system
+ 11. A steering
+ 12. A body, salon
+ 13. A central air
+ 14. An electric equipment




9.2.3. Removal and installation of the back bridge

Removal

PERFORMANCE ORDER
1) remove back wheels
2) remove the equalizer of ropes of a manual brake (the top arrow)
3) remove a rope of a manual brake from clips on fixing arms (the bottom arrows)
4) remove directing plug of a rope of a manual brake from fixing arms (are specified by arrows)
5) disconnect brake hoses from brake tubes (the right arrow)
6) remove nuts of fastening of the hook-on device (the left arrow). Do not take out bolts
7) disconnect a spring of a regulator of pressure of brakes from the back bridge

8) remove a bolt, крепящий a cross-section jet bar (the bottom arrow)
9) remove bolts of the bottom fastening of a rack of a suspension bracket (the top arrow)
10) remove bolts of fastening of the hook-on device (for performance of this operation it is necessary two persons)
11) remove the back bridge

Installation

Installation is made in sequence, return to removal. Thus pay attention to the following:

Pump over brake system, adjust a parking brake.